Menu Close

Can I use my own router with eir?

Can I use my own router with eir?

Can I use my own modem / router? Router: You can also use a third party router behind the eir modem (either as an access point or in bridge mode), however, we do not support configuring these devices, so you will need to take care of that.

What is bridge mode router?

What is bridge mode? Bridge mode is the configuration that disables the NAT feature on the modem and allows a router to function as a DHCP server without an IP Address conflict. Note: You will need to call your Internet Service Provider for the bridge mode settings.

How do I access my eir Fibre box?

In the address bar, enter http://192.168.1.254 and press Enter.

  1. Under User, enter admin.
  2. Under Password, enter your password.
  3. Choose LOG-IN. Note: the default username is admin and the password is the same as the WiFi password which can be found on the sticker on the back of the eir fibre box.

How do I access my eir router settings?

Open your browser, type 192.168. 1.254 into your address bar and press enter. The username required is admin. The password is the same as your WiFi key (printed on the base of your modem router).

Is the EIR router good?

I recently got Eir’s Fibre To The House (FTTH), I get speeds of 300Mbps down and 50Mbps up which is a big improvement over the 2Mbps down and 0.5Mbps up I previously had. It is a great service and I am very happy with it!

Is EIR modem good?

Great Value. The eir Smart WiFi hub is one of the best value WiFi 6 mesh devices in Ireland starting from €99.99 per device.

Why would you use bridge mode?

Bridge mode allows you to leverage two routers so that your business’s Wi-Fi extends across a larger area. In turn, you’ll experience faster speeds and better reliability. You might be wondering why you can’t just set up two routers without using bridge mode.

Why does my fibre say no Internet?

The cable connectors may not be fitted properly. Some problems may not be immediately evident to the naked eye especially when the Fibre cable is damaged internally. If the lights on the CPE/ONT are not on, there could be a problem with the device or link. You may be connected to a faulty port.

How do I reset my eir fiber router?

If you want to reset the factory settings for eir fibre box, press and hold the RESET button with a pin (like a paper clip) for 8 to 10 seconds until all the modem lights turn off, then release. Alternatively, you can perform a reset using the software interface.

How do I log into my eir Fibre router?

How do I reset my eir Fiber Box?

Posted in Blog