Menu Close

How do I reset my Honeywell CM67?

How do I reset my Honeywell CM67?

How do I reset the service time reminder on my CM67 programmable thermostat? 1. Put the slider located on the lower left side of the thermostat into the “Off” position. button and “PROG” buttons 3 and 4 all at the same time.

How do I change the battery in my Honeywell CM67?

Open the battery compartment by inserting a coin underneath the bottom right edge of the flap and lift out. Replace the used batteries with 2 new AA LR6 Alkaline Batteries (Duracell are recommended) and push the battery compartment firmly back into the front of the unit. RESPECT YOUR ENVIRONMENT!

How does a Honeywell wireless thermostat work?

Honeywell wireless thermostats can improve the control over the temperature in a room by sensing the surrounding air temperature and adjusting the heating accordingly, creating an automatic system which naturally conserves energy.

Does a Honeywell thermostat have a battery?

The battery compartment on a Honeywell thermostat is located on the side of the device. To remove it, first push the tab on the top of the thermostat. Then pull it to remove the compartment — it should slide right out.

Why is Honeywell thermostat blank?

If you own a Honeywell thermostat, the blank screen could be an indication of a furnace door that wasn’t completely closed. These thermostats are programmed to shut off entirely if a furnace door is open. To rule this out, double-check to make sure your furnace door is fully closed.

Is there a replacement for the cm67 programmable thermostat?

The CM67 programmable thermostat has been discontinued. A functional replacement for the CM67 programmable thermostat is either the T4 programmable thermostats for wired models or the T4R programmable thermostats for the wireless versions. What should I do if I get a “System is offline” message on the T6/T6R Smart Thermostat?

How to use the cm67 to control the heating?

The CM67 will now control y our heating using each da y of the week? 1. Move the slider to PROG. The rst temperature change time and temperature le vel is shown). 2. Press to adjust the rst temperature change time.

What is the cm67?

the CM67? 1. Automatic Time Setting (A TS) “Add-On” Module * Europe and corrects the time on the CM67 display. So: this information to set-up all your other cloc ks. and home location. 2. Outside T emperature Sensor Accessory to display the outside temperature. By pressing the CM67 displays the e xter nal temperature. 3.

Who do I contact for troubleshooting on the cm67?

See the troubleshooting guide below. If you need assistance after this, call your Heating Installer. The CM67 should only be opened or remov ed by a qualied professional to pre vent possible injury from electric shock.

Posted in Other