Where should pull handles be placed on kitchen cabinets?

Where should pull handles be placed on kitchen cabinets?

For both upper and lower cabinets, the pulls should be installed vertically 2 ½ – 3 inches in from the corner of the door. For drawers, they should be installed horizontally in the center of the door. While there is no hard-set rule for the size of your pulls, consider using longer ones on larger drawers and cabinets.

Where should my cabinet pulls go?

When it comes to installing cabinet door handles (either knobs or pulls), they are always placed on the opposite side from the door hinges. You’ll specifically want to place them anywhere between 1” and 4” from the top or bottom edge of the door.

What size should cabinet pulls be?

Determine Size While there is no set rule, we generally recommend that the pull length is approximately 1/3 of the cabinet or drawer width. Small Drawers that are 12” or less typically work best with a pull that is 3” to 4” long or a knob that is 1” in diameter.

What color door hardware is in Style 2021?

Matte black in particular, will be incredibly popular for 2021 and going into 2022. In fact, matte black is trending in all forms of hardware – from cabinets to door knobs and light fixtures.

What is the current trend for kitchen hardware?

Both copper and gold add a rich warm tone to cabinet hardware. Gold-toned finishes are a new and compelling trend. The gold finishes that are being seen now tend to be rich and deep with a brushed finish. They look stunning against both light and dark cabinetry and add a formal touch to any kitchen.

Where do you put cup pulls on drawers?

Cup Pulls: Cup pulls are only ever used on drawers, and I like to center them in the middle of the drawer slab. If you have a 5 piece drawer (top and bottom rails, inside panel, and side rails) you want to make sure the hardware itself will fit (centered) in the middle panel before purchasing and installing.

What are standard cabinet pull sizes?

For standard size cabinetry (dimensions of 12″ – 36″) the most common pull sizes are 3”, 4”, 96mm, and 128mm center to center (from one screw hole to another). Standard knob sizes are 1 1/4″ or 1 3/8″.