Why is the auger on my pellet stove not working?

Why is the auger on my pellet stove not working?

If the auger is no longer turning, chances are that it is experiencing a motor failure, pressure switch failure, or that it is clogged from pellets and debris. The best thing to do is to first unplug the stove and open up the compartment to test the motor and then clean it out completely.

How long should a pellet stove auger motor last?

The average pellet stove auger motor will last approximately 6-8 seasons running fairly consistently in season during moderate to severe climates. We have seen some go 10+ years, and some go in under a year, but the average is 6-8.

How do you check auger motor for continuity?

To determine if the auger motor is defective, pull out the ice bucket and turn the bucket auger by hand. If the auger turns freely, use a multimeter to test the auger motor for continuity. If the auger motor does not have continuity, or if the motor is getting power but won’t run, replace the auger motor.

Why are my pellets not dropping?

If your Harman Stove has stopped feeding pellets, there could be a few simple solutions: The front door, ash pan door or hopper lid may not be closed properly. Fill the hopper and allow a few minutes for the unit to auger the pellets onto the burn pot. …

How do you know if auger motors are working in refrigerators?

What does auger motor do?

An auger motor is a motor used to power an auger, a drill-like tool used for making holes and removing the material that filled the holes. An auger without an auger motor is called a hand auger. Hand augers tend to be more difficult to use because one must use a handle or brace to manually rotate the auger’s bit.

What does SAIA Burgess make?

Saia Burgess, part of the Johnson Electric family, is a manufacturer of motors, solenoids, switches, sensors, electronic controllers and subsystems for the automotive, industrial and building automation industries. Johnson Electric brands distributed by Sager Electronics include Saia Burgess, Ledex and Dormeyer.

Is This auger/feed motor any good?

This auger/feed motor worked great, although getting the auger off the old motor was difficult. Direct fit, and easy to install. Solved my pellet stove issues. I listened to that stove whine and hiss for almost a year before the motor finally went. Now it runs silent, and keeps pellets fed easily.

Which Quadra Fire models does the auger/feed motor work with?

This is an Aftermarket Auger/Feed Motor for Freestanding and Insert Quadra Fire Models: *Castile, *Santa Fe, *CB1200, *Contour, and the *ORIGINAL Mt. Vernon. This motor is NOT the correct part for the AE, Edge 60, or the 800 & 1000 models. **This motor will also work in the Heatilator Eco Choice models PS35, PS50, and Cab50. Quadra Fire 812-4421